Wireshark and GeoIP (by Betty Dubois)
LMTV Case Study | Top 10 Scary Nightmares for Network Professionals (by Brad Reinboldt)

Using Microsoft Netmon at the Command Prompt (by Tony Fortunato)

After my last article about Microsoft’s Netmon got quite a bit of attention.

One common point raised by more than one person is that Netmon would be so much better if it had command line support.

I knew it did, but never used it and was surprised how feature rich it was.

In the following video I go through some of the basics to get you going.

Here are the commands I used that you can copy and paste to save some keystrokes.

  • Nmcap /usage
  • Nmcap /displaynetworks
  • NMCap /network 3
  • NMCap /network 3 /capture /file 3.cap
  • nmcap /network 3 /capture ipv4.address == 10.44.10.1 /file ip.cap /StartWhen /Time 4:48:00 pM 10/22/2014 /StopWhen /TimeAfter 20 min

Enjoy

 

 

Continue reading other LoveMyTool posts by Tony Fortunato »

Comments